DIY Woven Chain Bracelet
"Chain link bracelets, with colorful threads woven through them, have been popping up here and there. We adore Aurèlie Bidermann‘s Do Brazil bracelets and thought it was about time we graduate to the ultimate “grown-up” friendship bracelet. With a curb chain bracelet and some embroidery thread, we’ll teach you how to make your own woven chain bracelet. And one for your bestie too, of course."
- a curb link bracelet- embroidery thread
- two bobby pins
- a pair of scissors
Cut 2 sets of 15 strands of embroidery thread, with each strand measuring four times the length of the bracelet. Knot the all the threads at the top, leaving about 2 inches of slack. Sandwich each set between a bobby pin – this will help you easily weave the threads through the links of the bracelet. Lay the threads to the left of the bracelet. Pull the first color (coral) from under the first link and over the top of the left side. (Click images to enlarge)
Lay the second color (blue) over the first color (coral). Pull the second color (blue) from under the same link and over the top left again. Repeat the steps, moving onto a new link: put the first color (coral) on top of the second color (blue) and pull it out from under the 2nd link and over the top left. Lay the second color (blue) on top of the first color (peach) and pull it out from under the 2nd link and over the top left again. Because the links of this particular bracelet are large, I wove the threads through twice on each link. If you are using a smaller linked bracelet, you should weave through each link once like this.
Repeat the steps until you reach the end of the bracelet. Finish it with a knot and trim the ends.
(via HIGHSNOBIETY)
